Gateway Mode, DNSMasq, Static Leases & DHCP, Pi-Hole DNS & Running Unbound. OVPN Server With Paid OVPN client & Wireguard Client. Network IPV4 eth1 - Isolated Vlan eth1.3 on br1 For IoT Devices With 3 x Linksys velop Bridged mesh Nodes (Amazon Echos, smart TV's, etc.)īT Whole Home 4 Node Mesh Wi-Fi, Router Wi-Fi Disabled. Try changing compression to disabled (not no) I am not a network export and have tried to follow the guide but maybe I missed something.Īttached are screen shots of the configuration I am using. In Status > OpenVPN The State is showing as "Client: CONNECTED SUCCESS", but looking at the log the router seems to to connect / disconnect the NordVPN. This is with ìSource Routing (PBR)î set to ìRoute all sources to VPNî, I also added the command ìredirect-gateway def1î In "Additional Config". However any device connected to the XR300 does not go over the VPN it will always go directly to the internet from the gateway router. The XR300 is connected to the internet via an ISP router with IP address 192.168.1.1.Īccording to this thread the XR300 is a rebranded rebranded R6700v3 and therefore I used the builds for the R6700v3. I am using a Netgear XR300 router for VPN access using NordVPN and OpenVPN client, so that any device connected to the XR3000 goes over the VPN. Posted: Mon 9:09 Post subject: Help NordVPN OpenVPN client
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |